Riding Lawn Mower Blade Care

Sometimes it can be a riding mower or tractor with blades achieve balance, folded, with a need or a mat, and either repair or replacement. It is recommended that the maintenance performed on blades at least twice a year. Posted by mower blades, a lawn, follow the instructions below.

Note: These materials are designed to be used by technicians who were interested in the service and repair of equipment, preparation described in this publication are not experienced andfor use by persons untrained or inexperienced. These people should contribute to a service technician or dealer.

Preparation

As with many projects, think about safety first. Always wear heavy leather gloves and safety glasses / goggles and always unplug the mass of the battery terminal of the battery and power cord from the candle. When the device is equipped with an engine with two cylinders, remove the twoCables candle candles.

Remove leaves

Most of the riding mower blades are replaceable. To reach the mower, lawn mower, remove the bridge before performing maintenance work. Do not point the riding lawn mower on its side. This can cause serious damage to the device. Remove the blade by turning the tractor mower blade bolt or nut counterclockwise with a standard long-handled key. Do not be surprised if the blade or boltThe mother is difficult to remove are due to normal corrosion, dirt, construction and initial torque of 70-100 ft. lbs.

Sharpen blades

Sharpen the blades riding lawn tractor with an instrument such as a file in hand, which is intended to be used on hard metals. It is not essential that the blade is sharp as a knife. A margin of about an angle of 45 degrees will be sufficient. Most wear around the tip of the blade. Focusing on this sector. If the blade is significantlygouged or worn on repairs, replace the blade. Follow the steps above for all knives.

Balancing blades

Before installing a new blade or sharp, it is important that the blade is balanced. If a leaf is not balanced correctly, it will rattle and vibrate. This will damage the other components of driving lawnmower. Blade-balancing tools can be purchased at local hardware store at a reasonable price. Clean all dirt and dust from the blade.If the blade is not thoroughly cleaned it will affect the balancing of the blade.

There are two procedures for checking the balance of a blade that we call out in this publication. The first is when using the vertical test method, the free hanging blade will rotate on its own, heavy side downward. The horizontal test method is the second; this is when one side of the blade begins to drop towards the table top. The side that drops to the table top or rotates downward is the heavier side, and needs further close or material removed to compensate for the blade. After sharpening, test the balance of the blade, and repeat until the blade is balanced. Follow the procedure above for the remaining leaves.

Installing Blades

Once the blade has been sharpened and balanced, you can install with the correct orientation. If you have an OEM blade that is the word "Bottom" printed on the blade to the side facing the ground. If the word "end" is notAt present, make sure to install the blade with the highest peaks in the direction of the upper deck. Blade bolt or nut must be tightened properly with 70-100 ft. lbs. Couple.

Recommend : Looking for reviews of leaf blowers vacuums Leaf Blowers Vacuums Garden Blower | All about of Garden Blowers